Siemens KNX Roller Shutter Actuator N 523-03 - 5WG1 523-1AB03 - siemens knx building automation system | knxstore EU online shop

- Integrated 1-bit scene control
- 2 Scenes to be integrated per channel

- Travel lock (e.g. for cleaning the outer shutter/blinds)
- Separate raising/lowering protection
- Individual configuration of actuator channels
- Shared configuration of actuator channels
- Adaptation of objects and functions to drive type

- Move to safety position
- Locking in this position for as long as alarm is active

- Bus voltage: carried out via the bus line
- N 523 electronics: integrated power supply unit 230V AC, +10%/-15%, 50Hz
- Supply voltage for bus: 21V DC to 30V DC

- 1 push button: for toggling between normal mode / addressing mode
- 1 push button: for toggling between bus / direct operation
- 4 x 2 push buttons: for direct operation of the roller shutter drives, independent of the KNX

- 1 red LED: for displaying normal mode laddressing mode (off / on)
- 1 yellow LED: for displaying bus / direct operation (off / on)

- Mains connection:
-- 2 x 2-pole (N, L1) (Li is also the power supply for outputs A and B)
-- 2-pole L2 (power supply for channels C and D)
- 4 load outputs for 4 roller shutters:
-- each 2-pole (Up, Down)
-- rated voltage: AC 230 V, 50Hz
-- rated current per relay contact: 6 A (resistive load)
-- Switching cycles: >20,000 at cos fi = 1

- Mains and load circuits plug-in terminals for mains connections and outputs
Insulation strip length 9 ... 10 mm
The following conductor cross-sections are permitted:
-- 0.5 ... 2.5 mm2 single-core
-- 0.5 ... 2.5 mm2 finely stranded with connector sleeve
-- 1.5 mm2 finely stranded, untreated (max. ampacity 6A)
- Bus line: Pressure contacts on data rail and bus terminal